dMT-SPC System

  • sistema-dmt-spc

dMT-SPC Products from Ecotech International provide a modern, efficient and labor-free method of protecting surfaces in the most difficult applications areas – in some cases the only method. The products are a mixture of special components (NO GRAPHITE) which bond with the metal surfaces and create a pre-determined, optimal coefficient of friction between surfaces for use in numerous industrial applications: Crane wheel flanges and treads, and all other types of wheel / rail-equipped systems; trunnions, rings and thrust buttons on all rotating equipment, (i.e. kilns, dryers, mills, etc.); AS/RS warehouse conveying systems, chains; locomotive wheel and many other applications.

dMT-SPC Blocks are the most economical in applications where conventional lubricants (greases and oils) cannot be used, or are used with high material and labor costs, especially in very dusty, high temperature or wet applications.

The System consists of a set of stainless steel applicator and the coating blocks.

Heavy-duty, spring-loaded, stainless steel applicators are delivered with the blocks. The spring presses on the block so the contact with the metal surface is constant. Installation is usually quite simple and low cost.
dMT-SPC Blocks coat metal surfaces with a solid, non-migrating, protective layer approximately 10 microns thick. The products are a mixture of special components (NO GRAPHITE) which bond with the metal surfaces and create a pre-determined, optimal coefficient of friction between surfaces in contact. MoS2 possesses exceptional qualities against wear and friction and metal contact is reduced by up to 80%, thereby increasing the life of metal parts from 3 to 5 times.

Results

(a) Maintains a constant, optimal coefficient of friction between the contacting surfaces :
-Block type T creates a low value of ca. 0.05 that favours sliding.
-Block type M creates a much higher value of about 0.30 (traction effect to prevent slippage).

(b) Protects the metal surfaces from flaking, pitting, etc. Wear of the metal surfaces is reduced, therefore increasing substantially the life of these machine parts.

(c) Manual application with all its disadvantages and costs is not required.

dMT-SPC Blocks are supplied in various lengths and widths to coat all metal surfaces from 19 – 60 mm wide. For wider surfaces blocks can be mounted adjacent to each other or custom solutions can be offered.

Advantages

-Absolutely dry and dust repellent.
-Do not drip or ‘migrate’.
-Maintenance-free and long-lasting.
-Coat continually & uniformly, reduce wear.
-Coat wet surfaces.
-High temperature resistance (300 ºC / 575 ºF);
-Not harmful to the environment.
-Noise reduction, (i.e. on locomotive and rail car wheels / rails).

Applications

Link here to the applications Section dMT-SPC

Industry and port cranes, Rotary equipment, Automated Warehouses AS-RS (stacker) and other Automation devices.

PDF’s

-See PDF Technical Information dMT-SPC Systems
-See PDF dMT System Dry Coating for Rings & Rollers of Rotary Kilns
-

Tweet about this on TwitterShare on LinkedInShare on Google+Share on Facebook